Gossen Mavomonitor Bedienungsanleitung PDF herunterladen (Seite 11)

GOSSEN Foto- und Lichtmeßtechnik 11

9.2 Battery Control

When the instrument is switched on the green LED

on the right of the ON/OFF switch lights up. When

the battery is exhausted the red LED to the left of

the ON/OFF switch will light up. You should then

immediately replace the battery.

A new alkaline-manganese battery will last for

approx. 60 hours of continuous measuring.

9.3 Preparing the Measurement

Screw the protective filter supplied with the instru-

ment or one of the close-up lenses on the ocular of

the MAVO-SPOT. For measuring either the protec-

tive filter or one of the close-up lenses must be

attached. Connect the MAVO-SPOT with the

MAVO-MONITOR by means of the connection

cable.

Select a suitable measuring range at the

MAVO-MONITOR and switch both instruments on.

9.4 Measuring

View through the ocular of the SLR viewfinder of

the MAVO-SPOT and direct the measuring circle

you see in the viewfinder to the area to be meas-

ured. This area should be illuminated uniformly

and be as large as possible as compared to the

measuring circle.

After that press the memory switch of the MAVO-

MONITOR and read the measuring value on the

display. When the measuring range is exceeded,

switch over to the next higher range and repeat the

measurement.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Gossen Mavomonitor Bedienungsanleitung Seite 11